Jump to content
Ultimaker Community of 3D Printing Experts

jonbonne

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  1. So I've had a small issue just recently with my Ultimaker Original+ printer. I'm printing with ABS at ~240C and heated bed at 100C. The print starts fine and goes well until about ~3-4 centimeters up. At this point, it looks as if the nozzle is clogged or something as the material begins extruding non-consistently and spit-sputter stringy... but after about 4-5mm of this behavior the extrusion returns to normal, the nozzle begins extruding smooth and consistent again and the rest of the print completes satisfactory as long as the print-product doesn't break at those weak layers (which it usual
×
×
  • Create New...