vsnpl

Dear Brulti, Thanks a lot for the guidance! Regards, Vaibhav

Dear All, A model when sliced with Cura shows that 2m of material (PLA) is required to 3D Print it. Does that mean if I have about 2m of PLA filament or a little more than it, will that be sufficient to print the part?? Or should we have additional material on the spool, equivalent to the length of the bowden tube ? Kindly advise. Best regards, -Vaibhav

Dear all, I need to use Polymaker Polysupport on the Ultimaker3. Can I use PrintCore 'BB' for the same? I am interested to know as to whether the above will be possible as I am observing that the support structures generated by Cura when I select coreBB and PVA are much better, than when I select coreAA and Polysupport. So will using polysupport on CoreBB create the same magic of improved support structures? Kindly advise. Thanks! -Vaibhav