Dear new-bee + expert,
I have an Ultimaker original and want to build a Kossel Mini. I want to use Cura on the Kossel. I do not know if I need to use a particular board in the Kossel to do this.
Which electronic board have you used?
Thanks
Gunther
Normally, Kossel Minis are run on Arduino MEGA 2560 + RAMPS 1.4 Shield. You can ALWAYS use Cura as a slicer but if you intend to run the printer headless(directly connected to your computer, relaying gcode via usb), you can use Cura.
However, I recommend that you just slice using Cura and relay via PRONTERFACE since Cura really doesn't like to recognise the printer.
Max