Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
  1. what are the reasons for the offset in the center point of the buildplate. the Second diagram in the picture i have uploaded shows the center point which i calculated by printing a small circle of 1mm radii at [0,0] cordinate in Cura..
  2. How does Cura decide where the body fixed co-Ordinate system(the one which appears on the body when you are in the move command) is placed? It appears to symmetric to the part in the X-axis but not in the Y and Z-axis...
  3. What all parameters does Cura take into consideration when it decides the amount of material it should extrude through the nozzle? I am trying to write a G-code manually but the print does not come out good as amount of material specified is maybe not right.
  • Create New...