kristjan_v

That is a good point. Well, we are a robotics club associated with the school. And, the school is on summer break, and no one should be in the class room. But, we can't completely rule it out. But, it is fairly unlikely.

We got our new Ultimaker 3 Extended. We printed a few short builds and everything was going fine, so we decided to go for a very long and large print, a Eiffel Tower that would barely fit in the bed. We also setup a livestream from the printers camera by having a second computer access the stream and publish that to youtube and we also setup a script on that computer to create a timelapse. The print should have taken 7 days. But, after about 15 or so hours the printer stopped. We were out of the building but, when we finally got access to it today, 3 days after setting it to print, the screen showed an error about the print having been aborted. Here is the timelapse video: Here is the gcode file along with the log files that I got off the printer. I'm not sure what version it was using. When the problem was active, because I updated it today and didn't look. https://drive.google.com/drive/folders/0B9iG50m_tfS0akdyeGlHbG5mQW8?usp=sharing Here is the error message I saw when I looked at the printer today and what the print looked like: http://imgur.com/a/rrRh0 We got the printer on the 19th of July. The reseller came to us with the printer and helped us set it up. We printed a calibration print, a small wizard DnD mini and a tractor. Then we set the printer to print the eiffel tower, somewhere around 21:00 that night. Not sure when it stopped exactly, but we discovered it by looking at the livestream at 15:00 on the 20th of July.