LesF

I have used infill meshes in previous versions of Cura, it seemed quite easy to set up in the past. Now I can't get the infill mesh to show up in the slice preview. [Edit] Re-installed 4.10, tried the same setup and infill meshes work.

I would be happier if somebody had made a deb for Stable Debian, but anyways, where can I find the best instructions on trying to build this myself on 32bit Debian?

My printer is out in the cold garage, far away from my modern computers. I have an old 32bit notebook running Debian Stretch, which is connected to the printer. I would like to be able to build Cura for this device, is that possible at all? Printer: Wanhao Duplicator i3 plus.