Hi, everyone!
I upgraded my UM2 Extended to a UM2+ Extended with the UM upgrade kit. After installation, I updated the firmware to 2.6.2 through Cura per the kit instructions. After the update though, my build plate is crashing into the print head when raising the plate to start a print and when selecting "Raise Buildplate" from the Maintenance menu. I've tried a couple of things already with no results:
Rechecked all of the connections on the board to make sure nothing was accidentally unplugged when installing the new extruder
Reinstalled the firmware
When running through the leveling routine, the plate stops in the correct location. My searches have turned up very little that fits the bill for this situation, so any ideas and/or advice will be greatly appreciated. Thanks in advance!