Koenvanos2

Thanks for your suggestion. That works well for top layers. I would like to see bottom layers only at Z=0 level (printed on the printable). At higher Z levels I do not want to see bottom layers printed on horizontal areas. However Cura prints them as bottom layers too. And with zero infill below this will result in problems.

I would like to see 'walls' and 'bottoms' only. 'walls' made in a Spiralized way and 'bottoms' only at the printing table level. I played with 0% infill and bottom only, but than I still have 'bottoms' printed at higher Z-levels, which I would like to avoid. Thanks!

Hi, I was very happy with the function ' Spiralize printing' with ' Bottom print' in the old versions of Cure. Currently I'm using Cura 2.7 and I cannot get this combination again. Is there any option or trick which I overlooked so far? Really appreciate your tips. Thanks, Koen