Jump to content

ultifanmaker

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    ES
  1. Hi I would like to ask if there is any option in Cura to avoid the mark when finishing an impression. It always occurs to me that at the end of the print, the nozzle stays for a moment on the printed piece and this causes a small mark in the form of a small crater. Is there any parameter in cure to prevent the nozzle from remaining on the piece at the end? I also use Simplify 3D and with this software this does not happen. Thank you
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!