Jump to content

JackTheSlicer

Dormant
  • Posts

    3
  • Joined

  • Last visited

Personal Information

  • Country
    DE

JackTheSlicer's Achievements

0

Reputation

  1. Thank you! I have a ultimaker3 and i'm currently running cura 2.7. I'm using a prime tower but the non-active printcore is heating up too early which results into oozing onto my print before switching printcores/using the prime tower. I've seen those cool down/heat up values in cura, but didn't know how to change them. Those cfg-files might help me out. I guess first i'm going to try out some unrealistic fast heat up values [°C/s].
  2. Is there no way to control the preheating behaviour? :(
  3. Hey there, i'm having a hard time trying to dial in dual extrusion with Colorfabb XT. I need to print dual color with colorfabb xt. I created a new material profile xt which is linked to cpe, as cpe it is close to my disired print temperature. The retractions settings and so on are all dialed in. My only problem is that the inactive printcore is heating up way too early which results into oozing and poor printquality (i have to throw those parts away). This problem wont be fixed with even more aggressive retraction settings. Is there any way to manipulate the time between the printcore starts to heat up and the printcore/extruder switch? If possible i don't want any preheating before switching. Printtime is not important to me, i do need clean prints. Thanks in advance! JackTheSlicer
×
×
  • Create New...