Amer_pl

Tinker firmware, https://ultimaker.com/en/community/33482-tinker-firmware-introduction has option set steps/mm. It has option to move filament manually allso. It will helpYou to find extruder issue. Feeder motor has very low rpm. It is no easy to see it move or no. You can change motor current too. Good luck Paul!

Simplify3D, 230/90 degree, fan off. Nozzle temperature changes 224-235-224-235... Machine has front door and top cover. Now I tuned PID settings. The temperature is almost constans, 230 C+-2. The print is much better but far to perfrct. 224 C- same quality. Maby someone has an idea what is wrong. One side perfect, second - bed.

15 mm/sek

[/media][/media-thumb][/media][/media]