joheben
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by joheben
-
-
Did you try to play with it a bit
I had a much more fundamental question - where exactly to find the Mold function in Cura 2.7... it is not obvious! Answer (I found it): it is a Special Mode that must be made visible in Settings...Configuration settings visibility.
I plan to create a dissolvable mold in PVA, for molding silicon or any elastomer (then to think about splitting it for creating reusable molds in PVA).
I need to figure out how to somehow trim the safety margins in Cura (Ultimaker 3 firmware is not agreeing on the margin calculations, and even the non-mold print barely fits rotated at 45 degrees - I might have to rotate it at 45 degrees also in the Z dimension - ugly and wasteful of PVA...
Any comments or suggestions will be much appreciated!
Login loses focus on support forum
in UltiMaker.com
Posted
I found a forum for reporting Cura 3.1.0 bugs (directly from Cura), but after logging in (after recovering password), I have no idea where that forum was. "Bugs" or "Cura" should be visible at the top forum level (will find it again via the Cura software).