1Ghasthunter1

Just wanted to say thanks: I've been struggling with this issue for two years and this is the first official forum to have a post about this. I actually came upon this solution on my own by tuning the max resolution, but in the process, I bought a new raspberry pi, 2 new printer boards, and did a lot of work on my machine. Thanks!

Hello, I'm having trouble tuning my cura correctly for the Anycubic Kossel Printer. Does anyone have a premade settings file that I can use? It would be greatly appreciated. Thanks.

hello, Just in the past Day i Got octoprint working at it works great. Everything works, and I can print directly from cura or from octopi.local. The only issue is the prints are very gittery. I'm not sure whats up with this, but when doing a layer(like the first layer, second layer, solid layers) it runs fine. The moment it gets to the walls and any turns or bends in the wall, it starts to Gitter, making a horrible print. I am printing out a vase and will see how the quality is in the morning, but until then does anyone know what this is? I am using an anycubic Kossel Delta Printer on marlin 1.1.5 and Cura 2.7 (do note the Spiralize outer contour was enabled during this print). Thanks