Outpost31d

Having an issue on my model as it seems to perhaps over extrude at a certain height, or wondering if is might be cooling issues? I am printing on the sprint setting with a 0.8 nozzle at .4mm, curious as to what the issue might be. thnx for any ideas. Here is a vid of it as it does this https://youtu.be/blVPiLBHA9A

that worked, thanks so much for your help!

Thanks for the effort, yes its the same with all models

here you go, thnx crv.curaproject.3mf

Sure can, thnx! clamps.stl

Can't seem to get the support blocker to work. When I click it and try to place on my model my model blanks out?

Ok I think i've got it, thanks for everyones help!

Ok sry, now I'm a bit confused, attached a screenshot, there is wall thickness and wall line count. So my wall thickness should be changed from the default for the 0.8 core which is 1.37 to 1.6?

Thanks for that, the default line thickness (that is 'shell width'?) for 0.8 is 1.37 so i'll change that to 1.6. 'Retract on layer change' is off by default and I will try the tune menu. Appreciate your help!

t looks like little pin pricks. I just started printing with an 0.8 nozzle I used the core settings of course, the only thing I changed was the layer height to 0.4

Hi, I am new to 3D printing and I printed these two pieces on the fast setting. Just below the head as the print expands out it seems like filament is kind of pushing out between different layers, bulging out. Does fast always print like this or perhaps is there another setting I can change in fast that would remedy this issue? thanks for any suggestions