Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Everything posted by CEP

  1. merci -> combing mode off fonctionne
  2. Hello Is there Cura settings to avoid line on first layer (see attached) thanks
  3. Bonjour Comment régler les paramètres Cura pour éviter ces lignes parasite (voir photos) Que j'imprime en ASA ou ABS c'est la même chose merci
  4. bonjour - j'ai une enceinte fermée - température indiquée sur la bobine 220-270 ° - ma pièces fair 100x100 mm merci
  5. Impression d'une équerre ABS . Les bord se décollent et se soulèvent du plateau . j’ai essayé avec plusieurs réglages remplissage : 50% ou 75 % , température d'impression ABS 230 degrés ou 250 degrés …adhérence au plateau sans / avec Raft , - température du plateau 100 degrés - rien n'y fait !!!!
  6. thanks for the help have a nice day
  7. i did a another one : https://www.mediafire.com/file/slyuf55nc99hhwa/UM33_plaque110_project.gcode
  8. hi https://www.mediafire.com/file/w86nn646d3re1uy/support.gcode thanks Claude
  9. Good news the text is nice with out scratches Thanks a lot for the help P.S A small retraction off the character V subsist (if not really important but if you have a idea ? ) rgs
  10. I send a print with combing OFF, I'm coming in touch tomorrow rgs
  11. sorry https://www.mediafire.com/file/w86nn646d3re1uy/support.gcode
  12. Dear Mark See the I'ts much better but black lines subsist over the text , it's too bad gcodes : https://www.mediafire.com/file/r32pxv6byj0w61d/UM3_plaque_et_text_220v.gcode
  13. hi, really thanks a lot for helping I will try tomorrow where is the setting : retract before outer wall enabled and print outer wall first enabled Have a nice we claude
  14. thanks https://www.mediafire.com/file/r32pxv6byj0w61d/UM3_plaque_et_text_220v.gcode
  15. thanks I tried but is not better there is still a black line under the red text
  16. hi how to resolved the unwanted lines on surface ? see pictures thanks
  17. Hi I get the message : I cannot find cura on this computer Macro : Export_to_Cura_2.x.swp Solidworks : 2016 Cura : 3.0.4 Thanks CEP
  • Create New...