Jump to content

mzemba

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  1. I jumped from Cura 15 to Cura 3 recently, and I've been running into an issue where the "Abort Print" routine will end with a home of the Z-axis...which is a huge problem on printers that home Z on the bottom (potentially drilling your hot end into the aborted print). I found discussion on the issue circa version 2.7 (here and here), and it seems to have been fixed. When I checked out my USBPrinterOutputDevice.py, Line 626 is commented, "# Don't home bed because it may crash the printhead into the print on printers that home on the bottom". Is version 3 no longer using that file for the abort routine...? Are there any other reasons I would still be getting a Z-home when I abort?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!