So I took off the feeder on my UM3 to clean the feeder out. When I was putting the feeder back in I must not of had the screw straight in because the little brass part that the screw goes into pushed out and fell into the machine behind the white plastic part that protects the feeder motor. I was able to remove the little brass insert piece, but I can't figure out how I could put it back in. It looks like I would have to remove the white plastic part that protects the motor, but there aren't any screws to remove it with (there are several videos that show how to remove it on the UM2, but not the UM3).
On the picture the red circle is the hole that the brass thing is missing from (it is installed from the back). The green is the bottom one that still has the brass part in it. Any suggestions on what I can do?