Jump to content

Hammerd

Dormant
  • Posts

    6
  • Joined

  • Last visited

Everything posted by Hammerd

  1. I've had this happen when the model isn't in full contact with the build plate (in Cura). It's either too high or at an angle.
  2. Confirm you changed, and saved, the "default_steps_per_mm" value in the firmware. I've had my UM3, with the new DDGs, running almost 24/7 since I installed them. No issues.
  3. I just ordered some of the Break Away. Looking for a solution that works with the higher temp build materials. I've also tried Scaffold Snap (E3D) but I can't get it to work with ABS any better than the HIPS. Hopefully Ultimakers' Break Away isn't the same as Scaffold Snap.
  4. I ran some smaller prints first, but I'm halfway through a 4-1/2 day print right now and they're chugging along. I'm very happy with them so far. No issues with the hardware or software.
  5. I'm having the same problem.
×
×
  • Create New...