Maxwell

Hmmm... this is weird? When I tell it home (via Level Build Plate) in Cura the problem persists but when I tell it to home in Pronterface it does it just fine

Hey all, so I've been trying to get an older Ultimaker working and I'm having a fair bit of issue and I'm not sure what to do at this point. So the Z-Axis isn't homing right to start with, in fact it will click the switch while homing then move down about an 8th of an inch for no reason. I've tried adjusting the screw that hits the switch and moving the switch itself, but the problem still persists. Because of this I'm completely incapable of leveling the bed (the screws aren't long enough) and also when I try to print anything despite the issues it refuses to move up or down. All of the limiters are clear of debris and all of the connections are secure and I've updated the firmware multiple times to double check. I don't know what else it could be