Jopie

Oops. I now remember I've looked at these parameters for the fist time a few days ago, but forgot I changed anything there. Thanks a lot for your very fast support.

Yes, there’s 2 versions for this model, but both give the same result. I will add the .3fm file. I can add the gcode file as well if it helps Phase_10_Card_Box_Top.3mf

I added some pictures of skewed, sliced lids, the Cura4.5 shows What it should look like, Cura 4.6.1 is the result with 4.6.1.

I tried to print a box for my Phase 10 cards. Found one here: https://www.thingiverse.com/thing:2714917 But when I sliced it with Cura 4.6.1 with my default parameters, the box gets filled in with a bottom of about 1 cm. The lid ends as a brick..... I finally sliced it with Cura 4.5, same parameters. No problem. Is this a bug or am I missing some new parameter here?