Jump to content

Jimbo965

Dormant
  • Posts

    6
  • Joined

  • Last visited

Personal Information

  • Country
    GB
  • Industry
    Engineering

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Jimbo965's Achievements

1

Reputation

  1. What about the problems with printing S3D files? That's a common problem in this thread...
  2. The recovery image seems to have been updated as I followed Gr5 instrusctions and version 4.3.3.20180529 was on the printer after the power cycle
  3. I followed the instructions to recover from the link below. Need to create a recovery image on microSD and plug it in the processor board and let it boot up. Then power cycle and recalibrate the print head swap position. I haven't done it before and it was pretty straightforward.
  4. I also got the new profile from S3D but there appear to be more issues with 5.2.8 than just Gcode. Have now recovered my UM3 to last version before 5.2.8 and all is working again. Wasted few hours on this and won't make the mistake of just accepting a firmware upgrade in future :-)
  5. Just loaded the 5.2 firmware and S3D files won't print. Cura prints are working but I also need to be able to print S3D files. Hope there will be a fix or workaround for this soon?
×
×
  • Create New...