Hello Everyone,
I have ultimaker 3 Ext that I have been using since last 4 years for my R&D work. I use it only 3-4 times in a month.
So its relatively new machine only.
Since last two weeks I am struggling to print an important part..
The moment I print, the printer restarts after about 4-5 sec.
The movement is seized immediately..
I have tried to heat the build plate & that works fine ..
I have run switching test diagnostics & that runs fine..
However, when I tried to run active levelling it does give the same problem & restarts in about 4-5 secs..
Can anyone please advise some solution ?
Thanks you very much