Jump to content
Ultimaker Community of 3D Printing Experts

alexbln01

Member
  • Content Count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • 3D printer
    Ultimaker 3

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. alexbln01

    UM3 Cam über Internet und Astrobox mit UM3?

    Hallo, hast Du die Astrobox beim Ulti 3 am laufen bekommen ? Meine kommt heute und nun lese ich das sie nicht kompatibel sein soll....
  2. Does anybody know if the automatic calibration is still working on the Ultimaker 3 Extended? https://www.geckotek.co/product/geckotek-magnetic-base-build-plate-for-ultimaker-2-and-ultimaker-3/
  3. hello .... can you install a function where you can set the z height in the menu a bit higher? especially for permanent printing plates it would be interesting so you could use the automatic active bedivelierung again .... had such a function on sigma ... you have the bed automatically leveled and then you could put it a little higher in the menu, this was synonymous then saved as a new z worth ....
  4. alexbln01

    Ultimaker 3: Firmware v4.2.9 | Test version

    If the client is authenticated, you can use the endpoint HTTP: // <Printer_IP> / Print Job / Gcode to download the Gcode of the currently printed object. ....... this function is cool .... I sometimes annoyed quickly printed on wifi and the gcode was gone .... will there be a function where you can store the gcode on the usb stick?
  5. alexbln01

    Cura 3.XXXX vesrion UI problems...Bug

    that is the same for me, all drivers are up to date ... can not use cura so that's no fun .... all programs run smoothly only cura 3 makes problems .... I've given up the time is too bad for me, currently I use s3d .... I have also made all the tricks described but it remains so slow ....
  6. that is the same for me, all drivers are up to date ... can not use cura so that's no fun .... all programs run smoothly only cura 3 makes problems .... I've given up the time is too bad for me, currently I use s3d .... I have also made all the tricks described but it remains so slow ....
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!