VictorDxx

I tried all solutions from Ultimaker website but non of them work. Here is my solution: First heat the stucked nozzle to 200-215 degrees. (To melt the material) Put a segment of PLA material in to the stucked print core/nozzle until it does not go in anymore Keep the material in the nozzle and apply some preasure Lower the temperature to 80-90 degrees while keeping the PLA material in the nozzle (To let both stucked material and PLA cool down so they become a whole) Pull the PLA out and the stucked material should come out See Picture Below The pink thing is PLA material I used to pull the material out of course I cutted it, the brownish translucent thing is the PVA material stucked in the nozzle.