I recently purchased my first roll of Ultimaker CPE. I previously used PLA, PVA & Nylon with success, but I am not completely satisfied with the results using CPE. When using PLA and Nylon I found that the default Cura settings worked great. But using CPE there appears to be an minor issue with stringing / oozing / blobs, as you can see from the attached image.
Can anyone offer advice?
Do the Cura settings need to be tweaked or is it something mechanical.
The printer is only a couple of months old and has seen very little use so I doubt that it is mechanical.
Thanks in advance for the help.