Jump to content
Ultimaker Community of 3D Printing Experts

Don Elliott

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by Don Elliott

  1. I'm using cura 3.1 in Repetier-Host and my question is if I increase the first layer in cura slicer, The height is correct to what I tell it to be but the fulfillment feed rate increase very fast layer than on the 2nd layer it slows back down to where it's set at. What is going on??Is this something in cura it self or something I'm doing wrong????
×
×
  • Create New...