wozDaddy
-
Posts
3 -
Joined
-
Last visited
wozDaddy's Achievements
0
Reputation
-
Origin At Center WAS Checked !!! Thank you so very much !
-
The A8 has 0,0 in the front left. I will check the machine config as you suggest. I will post results. Thank you.
-
G-code. All X,Y values - (Negative) CURA 3.1 My Anet A8 printer started limiting out in X. ( Keeping in mind this has not happened before) I found by comparing-codes that all my X,Y moves were all negative. What in the world changed ? Is there a parameter that I need to change ?