Alex_PrintrbotPlay

I used to use Cura 2 for my printing, but I recently had to get a new laptop so I had to install the newest cura (3.1). After reading around, I found that there is no more pronterface in Cura 3.1????? I have a printrbot and need used to use the pronterface to adjust my gcode settings for the Z-offset height (M212). But now without the pronterface, I am not sure how I can adjust the Z-offset, so my prints have not been good. Please can you tell me if there is another way to adjust the Z-offset, I used to use the M212 command in the pronterface, and M500 to save the settings, but now without pronterface, I am wondering if there is still a way to do that. Also, are you guys going to be adding another interface so that I can interact with the printer over USB cable, and type in commands???