Hi everybody,
And again...thanks for your answers !
Here are some pictures of my "problem"
My 3D model is 50x50x10mm (x/y/z)
I guess I have enough edges
@yellowshark >> yes I am taking mesurement at different height of the circle (top, bottom and middle)
I am using a sliding digital caliper. I know it is not that precise, but I think its enough to notice that my circle is not round (pictures enclosed)
The tension of all the belts has been done as well as the X and Y axes alignment.
All the pulleys are clean and tighten
I print PLA (205°C) with a bed at 40°C
The nozzle is a 0.4mm
Layer height is 0.1mm
Speed is 40mm/s
I did print another one at 30mm/s...it is a bit better but not as good as it should be, I still avec an average of 0.25mm error and the diameter
Thanks