Tony3d

Hi All, does anyone have machine end code for a CR10s Pro V2 that presents the part at the end of a run so the bed comes out to you, and not away from you at Y0? It’s crazy that the printer sends the bed all the way to the Y end stop. Sent it to Y200, and it went way past that so I turned it off to prevent it crashing in y. According to the code it looks to be an absolute move from Y0, so y200 should be nowhere near the end of its travel. I don’t get it.

Thankd all. Lots of great info here. Will have to experiment with this feature more.

Something else that doesn’t make sense is the variation is set to .1 yet it’s going to .27! Also, you would think it would distribute the higher resolution over the wave not pool in front of it.

I don’t understand how adaptive layers works. Can you set minimum and maximum layer height’s that can be used?