Hello, I have been printing some small objects recently and I have encountered some stringing and bad prints. I'm thinking it has to do something to do with my Cura settings. I have added my settings and pictures of the prints below. Is there an optimal setting for small prints? Also, any general tips to improve my print settings would also be appreciated. Thank you!
I'm printing with the monoprice select mini with PLA, my Cura settings are:
Quality:
Layer Height: 0.1mm
Initial Layer Height: 0.3mm
Line width: 0.4mm
Shell:
Wall Thickness: 0.8
Top/Bottom thickness: 0.8
Infill:
Infill density: 20%
Infill pattern: Grid
Gradual Infill Steps: 0
Infill before walls: yes
Material:
Printing temperature: 195 C
Build plate temperature: 60 C
Diameter: 1.75mm
Flow: 100%
Enable retraction: yes
Retraction distance: 1.75 mm
Retraction speed: 25 mm/s
Retraction Minimum Travel: 0.8
Speed:
Print speed: 40 mm/s
Infill speed: 40 mm/s
Outer wall speed: 25 mm/s
Inner wall speed: 40 mm/s
Top/bottom speed: 20 mm/s
Travel speed: 75 mm/s
Initial layer speed: 20 mm/s
Initial layer print speed: 20 mm/s
Initial layer travel speed: 37.5 mm/s
Cooling:
Enable print cooling: yes
Fan speed: 100%
Minimum layer time: 10s
Mesh fixes:
Maximum resolution: 0.01
Special modes:
Print sequence: all at once
