Jump to content
Ultimaker Community of 3D Printing Experts

sadibe1974

Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Other
  • Country
    CH
  • 3D printer
    Ultimaker 2+
  1. Hallo Zusammen Endlich habe ich meinen Ultimaker 2+ mit Octoprint zum laufen gebracht. Zuerst druckte er mein Objekt jeweils unten links am Rand und zudem ca. 1/4 kleiner :-) Jetzt habe ich nur noch ein kosmetisches Problem. Im GCode Viewer wird das Objekt nicht in der Mitte des Feldes angezeigt (siehe Bild) Jedoch druckt der Drucker mir das Objekt genau in der Mitte aus. Wo kann ich das korrigieren? Kann mir jemand helfen? Grüsse Sandro
  2. Hi, I have an Ultimaker 2+ and run this on an Octoprint. I managed to connect with Wi-Fi. Connection Cura to Ultimaker 2+ over Octoprint works. However, I had to change the Z axis because the path was reversed. If I have now selected an object via Cura and want to print it, he does not print the object as shown in Cura (in the middle) but starts the print on the front left. In addition, he prints the object about 25%, instead of 100%. Can someone help me? Especially I would be interested in what RepRap I have to enter in Cura ... there is "Marlin" or "Ultimaker" to choose from ... Regards Sandro
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!