Jump to content

viola0083

Dormant
  • Posts

    7
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker 3
  • Industry
    R&D / Exploration

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

viola0083's Achievements

1

Reputation

  1. thank you, eventually I used this to recover my UM3 to previous version, after few days testing/adjustment /calibration its officially back to life again this morning. next time don't just click (OK) when see new firmware update available. thanks again.
  2. Glad to know someone is still monitoring, however, I think the most efficient way is UM publish a new version, but in fact it’s older, hazard- free version, and most important of all, its updateed via USB. just my 2 cents best regards
  3. There is still some problem on attached profile,Tentatively it’s still not usable,However I think the most efficient way is UM publish a new version, but in fact it’s older, hazard- free version, and most important of all, its bees updateed via USB. just my 2 cents best regards
  4. I sent email to their local tech supporter, no reply at all, quite disappointing
  5. I'm desperate with this 5.2.8 firmware, please enlighten me how to restore to earlier version
  6. my problems on Ultimaker 3 after installing firmware 5.2.8 are: - no Wifi (haven't try the camera) after doing factory reset - cannot print if using S3D, I have also sent email to S3D for possible solution, they have worked a temporary U3 profile for firmware 5.2.8, I have tried and tested a few times but still have some problems: --- the machine will keep asking me to use the printhead that's not designated in my Gcode. am still keep trying and also same time hope Ultimaker can make a really stable firmware soon! attached S3D Profile for UM3, please try and share S3d Profile for Ultimaker 3 (5.2.8 firmware) best regards
×
×
  • Create New...