Jump to content

MrLogston

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

1 Neutral

Personal Information

  1. I tried moving it down slightly by dragging the arrow with no luck, not sure if it was .1, but worked as .32 and I just went with it, after two failed prints thinking my first layer wasnt sticking. Cleaning the bed for no reason..., I was happy to just get it printing.
  2. I used 3.2 with moving all parts down by typing in the z value -.32mm, a single layer height. And success
  3. I have this same problem, tried Cura 2.7, 3.0, 3.2 with no luck
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!