Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Everything posted by MrLogston

  1. I tried moving it down slightly by dragging the arrow with no luck, not sure if it was .1, but worked as .32 and I just went with it, after two failed prints thinking my first layer wasnt sticking. Cleaning the bed for no reason..., I was happy to just get it printing.
  2. I used 3.2 with moving all parts down by typing in the z value -.32mm, a single layer height. And success
  3. I have this same problem, tried Cura 2.7, 3.0, 3.2 with no luck
  • Create New...