EGropp

I am trying to print this test part https://www.thingiverse.com/thing:1810679.. The Cura settings are included with this file. I went back to the original version that they listed slicer settings for (version 2.3.1) and I am able to see the layers complete after i slice. It appears that there may have been a few functional changes to the Cura versions, i tried to print the part that i sliced in version 2.3.1 and was able to get closer, but there are still issues (i think possibly with retraction and extra prime). I would love to be able to slice and print this in Cura (the only thing i believe Cura does not do is a double wall on the first 3 layers). i am uploading both versions of the sliced file that i have I hope you see the same thing i do and may have a suggestion to get this sorted. v36-_P38_wingR1.gcode v2.3.1_P38_wingL1.gcode

I am trying to print wing test part for the P-38 from 3DLabPrint.com. When I slice with version 3.6, then look at the layer view shows all of the inner structure printing up to layer 172, then i get only the outer skin. The Solid view and x-ray views seem to be ok. When i print, i get what is seen in the layer view, all of the inner structure goes away and I get only the shell. Just to see what happens, i rotated the part 180 degrees to put the leading edge closer to the front (made no other changes) and re-sliced, now all of the internal structure has gone away. Could this be a limitation of my laptop, or an application issue?