UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I've been firing off a fair number of square prints that are annoying to cut/break free of full brims, but could use the adhesion help. In an effort to make it easier, I've turned off brims and manually placed small 1-layer-thick, 10mm circles at each corner of the print. The results are even more effective than a traditional brim, and a lot easier to remove.
Is there any way this could be implemented as a custom adhesion helper type? For these kinds of prints, it's a HUGE improvement…
Corner-only adhesion helpers?
in UltiMaker Cura
Posted
I've been firing off a fair number of square prints that are annoying to cut/break free of full brims, but could use the adhesion help. In an effort to make it easier, I've turned off brims and manually placed small 1-layer-thick, 10mm circles at each corner of the print. The results are even more effective than a traditional brim, and a lot easier to remove.
Is there any way this could be implemented as a custom adhesion helper type? For these kinds of prints, it's a HUGE improvement…