UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura Settings for Volcano with 0.8 mm nozzle
in Improve your 3D prints
Posted
I was having this same issue with the 1.2mm volcano nozzle.
By configuring the line width to be a bit larger than the nozzle it helps to minimize these gaps.
(im using 1.4mm line width)
also, there is a setting in slic3r under retraction settings called "extra length on restart"
I've found that setting retraction length to 0.1 and extra length to 0.5 helps.
i suspect that the volumetric pressure settings might help with this as well but i havent tried that yet.
i also recommend using at least the 1.3.0 version of slic3r.