Senior

Thanks, I appreciate the feedback. Like I've said, I have no instructions but I've seen how to level the plate and the steps to configure a Cura file, but is there a tutorial for what to do when I first turn it on. Are there model files in the "Jump" drive (does it plug into the back of the monitor) or does help with the setup? My home computer is Windows XP, so I don't think that will work with Cura. So, at work, could/would I convert a Solidworks file to Cura and load onto the SD card to put directly into the A6? Thanks again. Hope someday I can contribute to the forum.

I know I,m responding to comments make over a year ago but I have a problem that I need an answer to. I just built an Anet A6. Had the same problem of following the video and not looking at the + and - symbols on the motherboard. Plugged it in and got pops and smoke. One of the ribbons was slightly stuck to the processor as well as another wire to something else. Is the motherboard fried? Also, I did not get an SD card. The A6 was a gift from my son. Maybe he can get one from where he bought it. I saw a site to buy a new motherboard if I need it, but what about an SD card if he can't get it? My A6 did not come with any instructions on how to get started, so I'm searching the internet. Also, I use Solidworks at work. Can I use it to design things for the printer? I would appreciate any help to guide me to the right sources to get up to speed. Thank you.