Jump to content

JWhitten

Dormant
  • Posts

    2
  • Joined

  • Last visited

Personal Information

JWhitten's Achievements

0

Reputation

  1. Extra info regarding previous post-- I can't go back and edit that one for some reason... I've never used any version on this system prior to version 3.2. But the 3.3 version is a Beta, if that matters, but it was installed after I had the problems with the 3.2 version. So presumably it has nothing to do with those 3.2 issues. Also-- a previous poster mentioned a windows update having to do with graphics-- I don't know about updates. My system has been up and running for a week(-ish) since the last reboot and before the problems began. However, I do note that the last entries in the logs seem to have something to do with setting up for graphics of some kind. Perhaps there is a connection here?
  2. I have this problem too. I have been using Cura 3.2 for awhile now on Windows 10 with no issues. Then out of the blue with no obvious changes on my part it stopped working-- just hung and I had to kill the process. For a while after that I could start it by giving it admin privileges and then that quit working also. It just hung and refused to continue and never started up again no matter what I did. Finally I installed Cura 3.3 and went through the whole setup and printer tuning process all over again. It worked fine for a while-- several days-- with no issues. Then today with no obvious explanation it just hung. Killing it and restarting it doesn't help. Giving it admin privileges doesn't help. There's nothing obvious in the event logs and nothing obvious in any of the Cura logs. I've tried rebooting my machine and that doesn't help. I've checked for errant drivers and yada yada-- all clean. But when it comes to Cura, no workie. I'm getting by at the moment using Simplify3D but I would much prefer to be able to go back to using Cura as I'm used to it and I kinda like it. If it will help, I've attached the logs from the "..\AppData\Roaming\cura" folder and the "3.3" subfolder. If needed I can attach the logs from the "3.2" folder. Can anybody help me with this issue?? John cura.log stderr.log stdout.log
×
×
  • Create New...