Jump to content

Fulby

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Engineering
  • Country
    GB
  • 3D printer
    Ultimaker Original
  1. I've been using Cura 3.2.1 successfully for a few weeks but it is now hanging on startup. The main window appears but is all white and has the 'not responding' title bar. The problem appears to be due to it starting on my second monitor - I noticed in the stack trace (attached) that it was calling GetMonitorInfoA and disabling the second monitor caused it to start successfully on the first monitor. I then had to re-enable the second monitor with Cura open, then close Cura, to make it to open on the first monitor when reopened. I now know the work around if it happens again but is this a known issue and is there a better solution than temporarily disabling the extra monitor? Cura hang stack trace.log
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!