Jump to content
Ultimaker Community of 3D Printing Experts

JRich

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  • Industry
    R&D / Exploration
  1. EDIT: small change to the "Start gcode" (it wouldn't work correctly if you were doing duel extruder) I've been able to get Klic n Print to work with Cura, however it is a bit involved, and unfortunately, I'm new to Cura, and I haven't been able to figure out how to export the custom printer settings. 3 steps: 1) enter knp printer specs 2) enter in start/end gcodes (shown at bottom of this post) 3) make a small change to the top every gcode file you output from cura (If you don't it will still work, but your heated bed will always print at 130C for the fir
  2. I've been able to get Klic n Print to work with Cura, however it is a bit involved, and unfortunately, I'm new to Cura, and I haven't been able to figure out how to export the custom printer settings. 3 steps: 1) enter knp printer specs 2) enter in start/end gcodes (shown at bottom of this post) 3) make a small change to the top every gcode file you output from cura (If you don't it will still work, but your heated bed will always print at 130C for the first layer) (additionally, KnP seems to use its own standard for x3g files as well, as I haven't had any luck
×
×
  • Create New...