DanD

Thx Smithy! You were correct 🙂 That worked. I had no idea that option was available as I was using a very old 3.xxxx firmware Thank you very much for the quick response. I had been putting off updating Cura and my firmware for a long time and was regretting doing it today. Best regards Dan

Hi, I upgraded the firmware and Cura today. Ultimaker 3 Extended to the latest versions. Win 10 PC seems to see UM3 and I can see the machine settings. Browser has been attempting for an hour. Unable connect locally either. Printer can see the internet and I have rebooted it a few times since I upgraded the firmware. I'm able to ping the printer from the PC. I have rebooted the PC and restarted Cura a few times. On one screen "This printer is not set up to host a group of printers" On another "The printer(s) below cannot be connected because that are part of a group" Thoughts?