Jump to content

red_star_rc

Dormant
  • Posts

    16
  • Joined

  • Last visited

Personal Information

  • 3D printer
    I have no 3D printer
  • Country
    US
  • Industry
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

red_star_rc's Achievements

0

Reputation

  1. I can only repeat that Cura 4.3.0 didn't notice it and sliced correctly.
  2. Cura 4.3.0 didn't notice it and sliced correctly.
  3. Original model Sliced with Cura 4.6.1 Sliced with Cura 4.3.0 As you can see old Cura 4.3.0 sliced model better than 4.6.1 Printer Anet A8 Nozzle - 0.4 Layer - 0.1 Also movements are not optimal. So-o many extra unnecessary movements.
  4. No problem. I don't have time to experiment with new Cura right now. If nobody else reported similar problem I will try to play with it after finish project I am working on now. Older version don't have any artifacts and works perfectly for me. Thanks.
  5. Printer Anet A8. Artifacts is on Cura level, not printer. And YES I will use older version of Cura since it doesn't have bug I tried to point to.
  6. One more time. Slow. Cura 4.4.1 DOES NOT have any atrifacts. Cura 4.5.0 DOES. If you saying that defaults are wrong they should be changed. If you are saying that new Cura grabs my old profile and wrongly interprets it it should be fixed. Conclusion: New Cura doesn't work the way it suppose to be.
  7. All default settings were used with installation.
  8. Unfortunately I can't do it. Uninstalled 4.5.0 and reinstalled 4.4.1 No artifacts anymore.
  9. Noticed strange artifacts that appears after slicing in new Cura 4.5.0. Smooth before slicing. Appears on preview and print too.
  10. I had to reinstall 4.2.0 back. With 4.2.1 couldn't sometimes print simplest things!
  11. Definitely Support problem! Tried old gcode and it prints correct. New support mess up from the beginning. Especially on big and complicated models. On small simple models it works correctly.
  12. Bingo! Apparently hidden experimental option "Enable Bridge Settings" enabled by default. When I revealed and unchecked it I didn't find any M107 codes. Fan stays ON all the time during print now. Thank you so much!
×
×
  • Create New...