anwesh

Hello, Thanks for the information, I am just using ultimaker mother board for heating extruder hot end (do not need any sensor or x or y movements). I would like to extruder few materials at high temperatures (350°C). I have E3D liquid cooling hot end for this Purpose. I want to heat up hot end up to 350°C . Could you please tell me how to do this? I tried by downloading the firmware from github and changed configuration.ch file (168th line from 275 to 350) but it does not worked for me. Thanks, Anwesh

Hello Mr. Smithy, Thanks for the information, I installed the firmware by modifying 168, 169, 170 lines in configuration file but the thermocouple only reads until 260°C. If I disconnect thermocouple from heater the heater reaches upto 350 (which i change from 275°C in configuration.h file) and shown max temp error. May I know how to change thermocouple reading to 335 or 330°C value. I would like to use different extruder head with liquid cooling system to run at 330°C. Thanks, Best Regards, Anwesh Nettim

Hello, This topic is very interesting because I would like to modify my old Ultimaker 2 printer. I would like to heat up my nozzle to 320°C. I tried with changing 168 line in configuration file but do not know how to install this files on my Ultimaker. Is it possible to do it, if Yes, Could you please explain in simple way. this would be very helpful for me. Thanks, Best Regards, Anwesh Nettim

Thank you very much

thank you but it does not look like complete model, there is no threds on it to fix

2Extended+

i would like to print ultimaker nozzle with ceramic material by DLP printer to test some filled filaments, any nozzle diameter, Thanks

where Can i get Nozzle CAD model,