Jump to content

Jim8163

Member
  • Posts

    8
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer
  • Country
    US
  • Industry
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Jim8163's Achievements

0

Reputation

  1. It did for you-not for me. I was enjoying this hobby until the new Cura upgrade . I haven't been able to print since.
  2. I did try while Cura is running and it still did not work. Is there anything else that might be causing it not to work?
  3. I've never had a problem designing parts on Fusion 360, clicking on "3d Print", selecting the part, clicking "Cura" as the print utility and hitting "OK". Cura then pops up and I slice it and save it on my Ultimaker SD for printing. Now Cura won't even pop up after selecting the part and clicking "OK" like it always did before. I've uninstalled Cura and reinstalled it twice with no luck. I even upgraded to 4.8 and have the latest Fusion 360 version. Any suggestions? Jim
  4. Sorry about the delay in responding to your answer but no-it still does not work when Cura is open
  5. I've never had a problem designing parts on Fusion 360, clicking on "3d Print", selecting the part, clicking "Cura" as the print utility and hitting "OK". Cura then pops up and I slice it and save it on my Ultimaker SD for printing. Now Cura won't even pop up after selecting the part and clicking "OK" like it always did before. I've uninstalled Cura and reinstalled it twice with no luck. I even upgraded to 4.7.1. Any suggestions? Jim
  6. During assembly of the Original+, I broke the black plastic bolt clip ( pg 79 fig 221 of assembly manual) that holds on the knurled drive bolt of the feeder assembly. Is it possible to buy or get a replacement? It was part of the injection mold pack.
×
×
  • Create New...