Thirtythree3d

👍🏻 Thank you

SOLD

Hi guys. Does anybody know where i can download Ultimaker2_E3DV6.hex? All download links that I have found are no longer available. Just fitted an E3DV6 head and can't currently print due to the Heater cartridge not being supported on the Ultimaker board. Any help would be greatly appreciated.

Sorry the GO has been sold.

Currently yes it is still available

Yes still available.

Yes still available

It is still available.

No sorry just dropped it from from £2800

Price drop - UM3 £2000, UM2GO £600

Yes still available. 👍🏻

Ultimaker 2GO SOLD

UM3. £1600 Boxed no upgrades. No Cores included. Spare Print Head 1 x reel of pvc on NFC Reel 1 x spare NFC pla reel. In very good working order.

Hi guys and gals, I’m hoping someone can give me some advice. One of my um2+’s has stopped powering up. After a close look at the motherboard a resister L1 seems to have blown (picture attached). I do get one green led on. Does anyone know if this can be replaced or is there a work around? Or do I need to rob a bank and replace the board. Any advice would be helpful. Thanks in advance.

Ok I started thinking out of the box. I installed Ultimaker 2 firmware and then 2+. Then a factory reset. It now works as it it should. I'm thinking this was once an Ultimaker 2 with an official + upgrade. Thank you guys for all your help.

Yes everything set back to default and yes unmodified.

I did indeed have the wrong motor fitted. I replaced the motor with the correct one but the problem still exists. Any other ideas?

Looking that way. I'll report back as soon as I get the chance to switch it over.

I will give that a go thank you.

Did a test print, and the print was perfect. It's just the changing of material that now has this weird problem.

I used Cura to send some G-code to the printer to calculate E-steps. I found that after extruding 100mm in extruded exactly half (50mm) So I set the E-steps value to 738 double the preset value and the filament now looks like it will move the entire length of the bowden tube but the motor seems to be having issues. It makes a whirring sound and the filament skips as its being moved up the tube. I vaguely read somewhere about the motor settings needing changing after the e-steps value being altered but I can't for the life of me find it again.

Tried but no luck. Could the E-steps be stored somewhere the reset isn't touching?

I'll give it ago. Thanks again.

Yes the correct firmware was used. I thought a long the same lines with the feeder possibly being the issue but I fitted it to another machine running stock firmware and all seems to be working fine. Its very confusing. I've even tried a new motor to see if that was the problem but always the same outcome. Thank you for your help though