CynicalOwl
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by CynicalOwl
-
-
On 2/10/2018 at 5:06 AM, ahoeben said:
Here's a quick plugin: http://files.fieldofview.com/temp/LinearAdvanceSettingPlugin.curaplugin
Source: https://github.com/fieldofview/LinearAdvanceSettingPlugin
[snip]
Resurrecting for a bit - I'm in a similar situation, but I actually use two gcodes per filament - Linear Advance (M900) and Steps/mm (M92). Both of these can vary per filament - material type, viscosity, that kind of thing. I suppose I can reverse engineer the above plugin and add an additional setting for Steps/mm - any chance there's been discussion of adding a generic 'Start Gcode' field to the Material Preference tab? I'm accustomed to doing this in Slic3r and Simplify and prefer supported solutions when possible.
Gcode for different filament?
in UltiMaker Cura
Posted
K. I'll likely do the multiple machine profiles approach - settings in there aren't often changed, short of a wholesale revision of the start/end codes. After all you say manually editing config files is not recommended. Still think it's valid to have filament specific codes, but fine working through an adaptation in process from one slicer to another. Thanks.
-owl