Jump to content

Yves_K

Member
  • Posts

    5
  • Joined

  • Last visited

Everything posted by Yves_K

  1. Great, Thanks ! To be honest, I have not checked the top layers thickeness/number nor the infill, I just used the "by default" recommendations of Cura. I will check both as well as the temperature and also increase the infill when going up. Thank you again
  2. Has anybody seen this behaviour when printing flat surfaces with PLA, does it comes from the filament, from the print head or from the heated plateau ? This happened on two different prints. Thank you in advance
  3. Good afternoon, I am having adhesion problems with M ABS from NeoFil. This never happened before and I have printed numerous pieces without problem. Now I cannot even finish the brim of a piece and even less make an XY calibration. I have cleaned my glass plate, put a new coat of glue, checked and cleaned my nozzles, made a manual leveling, followed by an automatic leveling. Nothing seems to correct the problem. Any clue as to what can happen ? Thank's in advance
  4. Thank you for your answer. However the problem solved itself when I restarted Cura for the third time after a power shutdown. I had a message stating that my profiles had been corrupted and that I had to do a reset. Of course this erased evreything and I am recreating my profiles one by one. I will export them one by one now. Thank you
  5. I just switched to Cura 3.4 and I have no profiles left. Even by selecting an Ultimaker filament, Cura is unable to slice. In the menu Settings/Profiles I cannot create a new profile since the line"create profile from current settings ..." is disabled. Any idea on what os going on ?
×
×
  • Create New...