That is a good point, it didn't do this when I was printing Ultimaker material and using their pre-assigned printing parameters. It was only after I started using non-Ultimaker material and creating my own printing profiles that this started happening. I still am not convinced that it is a setting that I actually changed because the printing profile I created was made by copying one of the pre-made profiles in Cura and then changing some basic parameters such as printing temps, infill %, etc...
I have included screen grabs of my speed parameters in Cura. Do you guys see anything in the pictures that would speed up the bed fall?
If not, I am left to believe it is a bug that happens when you tweak printing parameters.
On a different note, is there any gcode Guru's that can assist me in editing my gcode until I can find the root of the problem?
I'm sure there is a way to add gcode at the end of the print to tell it to lower the bed at a certain speed to a certain height but I do not know what that would look like. If I could do that, at least I could shorten the distance that it does free-fall.